Crankshaft Inspection and Repair - Engine Cylinder Block Assembly
Crankshaft Main Bearing: Service and Repair
Thrust Clearance
CHECK CRANKSHAFT THRUST CLEARANCE
Using a dial indicator, measure the thrust clearance while prying the crankshaft back and forth with a screwdriver.
Standard thrust clearance: 0.020 - 0.220 mm (0.0008 - 0.0087 in.)
Maximum thrust clearance: 0.30mm (0.0118 in.)
If the thrust clearance is greater than maximum, replace the thrust washers as a set.
Thrust washer thickness: 2.440 - 2.490 mm (0.0961 - 0.0980 in.)