4 Runner 2WD V8-4.7L (2UZ-FE) (2003)
e. As shown in the illustration, tighten the nut of clearance to standard value.
Clearance: 1 mm (0.04 inch) --> Reference torque: 25 Nm (255 kgf-cm, 18 ft. lbs.)
26. INSTALL STABILIZER BAR FRONT
27. INSTALL FRONT STABILIZER BRACKET NO.2 LH
28. INSTALL FRONT STABILIZER BRACKET NO. 1 RH
29. INSTALL FRONT STABILIZER LINK ASSY LH
a. Connect the stabilizer link with the nut to the steering knuckle.
Torque: 70 Nm (710 kgf-cm, 52 ft. lbs.)
HINT: If the ball joint turns together with nut, use a hexagon (6 mm) wrench to hold the stud.
30. INSTALL FRONT STABILIZER LINK ASSY RH
HINT: Install the RH side by the same procedures with the LH side.
31. INSTALL FRONT DISC WHEEL
Torque: 112 Nm (1,140 kgf-cm, 83 ft. lbs.)
32. STABILIZE SUSPENSION
a. Jack down the vehicle.
b. Bounce the vehicle up and down several times to stabilize the suspension.
33. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
a. Fully tighten the nut.
Torque: 135 Nm (1,380 kgf-cm, 100 ft. lbs.)
34. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
DISPOSAL
HINT: Dispose the RH side by the same procedures with the LH side.