4 Runner 4WD L4-2.7L (3RZ-FE) (1996)
b. Using SST, install and torque the pulley bolt.
SST 09213 - 54015, 09330 - 00021
Torque: 260 Nm (193 ft. lbs.)
c. (w/ A/C): Install the No.3 and No.2 crankshaft pulleys with the 4 bolts.
Torque: 25 Nm (18 ft.)
9. INSTALL OIL STRAINER
Install a new gasket and the oil strainer with the bolt and 2 nuts.
Torque: 18 Nm (13 ft. lbs.)
10. INSTALL OIL PAN
a. Remove any old packing Formed In Place Gasket (FIPG) material and be careful not to drop any oil on the contact surface of the oil pan.
-
Using a razor blade and gasket scraper, remove all the old packing (FIPG) material from the gasket surfaces and sealing grooves.
-
Using a non-residue solvent, clean both sealing surfaces.
NOTICE: Do not use a solvent which will affect the painted surfaces.
b. Apply seal packing to the oil pan as shown in the illustration
Seal packing: Part No. 08826 - 00080 or equivalent
-
Install a nozzle that has been cut to a 2 - 3 mm (0.08 - 0.12 inch) opening or 3 - 4 mm (0.012 - 0.016 inch) opening.
HINT: Avoid applying an excessive amount to the surface.
-
Parts must be assembled within 5 minutes of application. Otherwise the material must be removed and reapplied.
-
Immediately remove nozzle from the tube and reinstall cap.
c. Install the oil pan with the 16 bolts and 2 nuts.
Torque: 12.5 Nm (9 ft. lbs.)
11. INSTALL FLYWHEEL HOUSING UNDER COVER AND DUST SEAL
12. INSTALL CRANKSHAFT POSITION SENSOR
Install a new O-ring.