4 Runner 4WD L4-2.7L (3RZ-FE) (1996)
/Page-335001.png)
Ignition Cable: Testing and Inspection
1. REMOVE AIR CLEANER CAP AND MAF METER ASSEMBLY
2. REMOVE INTAKE AIR CONNECTOR
3. DISCONNECT HIGH-TENSION CORDS FROM SPARK PLUGS
-
Disconnect the high-tension cords at the rubber boot.
-
DO NOT pull on the cords.
NOTICE: Pulling on or bending the cords may damage the conductor inside.
4. DISCONNECT HIGH-TENSION CORDS FROM DISTRIBUTOR CAP
-
Using a screwdriver, lift up the lock claw and disconnect the holder from the distributor cap.
-
Disconnect the high-tension cord at the grommet.
-
DO NOT pull on the cord.
NOTICE:
-
Pulling on or bending the cords may damage the conductor inside.
-
Do not wipe any of the oil from the grommet after the high-tension cord is disconnected.
5. INSPECT HIGH-TENSION CORD RESISTANCE