4 Runner 4WD L4-2.7L (3RZ-FE) (1996)
2. DISCONNECT SUCTION TUBE AND LIQUID TUBE FROM COOLING UNIT FITTINGS.
Torque:
Liquid tube: 14 N.m (140 kgf.cm, 10 ft.lbf).
Suction tube: 32 N.m (330 kgf.cm, 24 ft.lbf)
REMOVAL NOTICE: Cap the open fittings immediately to keep moisture or dirt out of the system.
INSTALLATION HINT: Lubricate 2 new 0-rings with compressor oil and install the tubes.
3. REMOVE 2 GROMMETS.
4. REMOVE DRAIN PIPE GROMMET.
5. REMOVE GLOVE COMPARTMENT PARTS.
6. REMOVE HEATER TO RESISTER No.4 DUCT.
7. REMOVE COOLING UNIT.
(a) Disconnect the connectors.
(b) Remove the 3 screws, bolt and the cooling unit.
INSTALLATION
Installation is in the reverse order of removal.
DISASSEMBLY
1. REMOVE THESE PARTS:
(a) A/C amplifier.
(b) Wire harness.
2. REMOVE BLOWER RESISTOR
Remove the 2 screws and blower resistor.
3. SEPARATE UPPER AND LOWER UNIT CASES
(a) Using a knife, cut oft the each packing.
(b) Remove 3 clips and 3 screws.
(c) Separate the upper and lower unit case.
4. REMOVE EVAPORATOR FROM LOWER UNIT CASE
REASSEMBLY HINT: If evaporator was replaced, add compressor oil to compressor.