4 Runner 4WD L4-2.7L (3RZ-FE) (1996)
Engine RPM Sensor (NE signal): Service and Repair
1. REMOVE ENGINE UNDER COVER
2. REMOVE ALTERNATOR
3. REMOVE ALTERNATOR BRACKET
-
Remove the 3 bolts and bracket.
Torque:
Bolt A: 74.5 N.m (760 kgf.cm, 55 ft.lbf)
Bolt B: 18 N.m (180 kgf.cm, 13 ft.lbf)
4. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR
5. REMOVE CRANKSHAFT POSITION SENSOR
-
Remove the 2 bolts and crankshaft position sensor.
Torque: 8.5 N.m (85 kgf.cm, 74 in.lbf)
-
Remove the O-ring.
INSTALLATION HINT:
-
Always use a new O-ring when installing the crankshaft position sensor.
-
Apply a light coat of engine oil on the O-ring.
INSTALLATION
INSTALLATION HINT:Installation is in the reverse order of removal.