4 Runner 4WD L4-2.7L (3RZ-FE) (1996)
NOTICE:
-
When connecting the wires to the ignition coil, insert the wire properly into the groove on the side of the ignition coil.
-
Be sure the wires do not contact with signal rotor or distributor housing.
4. INSTALL IGNITION COIL DUST COVER
-
Install a new dust proof packing to the distributor housing.
-
Install the dust cover.
5. INSTALL ROTOR
INSTALLATION
1. CHECK NO.1 CYLINDER TO TDC/COMPRESSION
-
If necessary, remove the cylinder head cover, and check the following conditions:
-
Turn the crankshaft pulley clockwise and align its groove with the timing mark "0" of the oil pump cover.
-
Verify that the timing marks with 1 and 2 dots are in straight line on the cylinder head surface as shown in the illustration.
-
If not, turn the crankshaft 1 revolution (36O°) and align the mark as above.
2. INSTALL DISTRIBUTOR
-
Install a new O-ring to the distributor.
HINT: Always use a new O-ring when installing the distributor.
-
Align the protrusion of the distributor housing with the groove on the driven gear.