4 Runner 4WD L4-2366cc 2.4L SOHC Turbo (22R-TE) (1987)
/Page-741009.png)
(b) Install the brake subassembly to the brake drum.
4. INSTALL AUTOMATIC LOCKING HUB
(a) Install a new gasket to the axle hub.
(b) Apply MP grease to the splines of the automatic locking hub body.
(c) Align the spring ends of the brake assembly with the knock pin.
(d) Check that the outer cam stopper is securely in the inner cam groove.
(e) Position the inner cam protrusion so it is centered between the outer cam protrusions and aligned with the knock pin hole of the hub body.
(f) Install the automatic locking hub body to the axle hub so that the inner cam protrusion is set between the ends of the brake spring. Then install
to the drive shaft spine.
(g) Check that the hub body fits perfectly on the axle hub, and install the six cone washers and nuts.
Torque: 315 kg-cm (23 ft-lb, 31 N.m)
NOTE: If the hub body and axle hub do not fit perfectly, reinstall them.