4 Runner 4WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1989)
Front Steering Knuckle: Service and Repair
Installation
Steering Knuckle Installation
Note: If installing a replacement knuckle, follow New Steering Knuckle Pre-Installation procedures before proceeding.
1. Apply molybdenum disuiphide lithium base grease to the drive shaft.
2. Push down the lower suspension arm and install the steering knuckle.
3. Connect the lower ball joint to the steering knuckle and install and torque the 4 bolts.
Torque: 58 Nm (590 kg/cm. 43 ft/lb)
4. Connect the upper ball joint to the steering knuckle and install and torque the 4 nuts.
Torque: 142 Nm (1,450 kg/cm. 105 ft/lb)
5. Install a new cotter pin.