4 Runner 4WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1989)
2. REMOVE AXLE BOLT WITH WASHER
3. REMOVE HUB BODY
(a) Remove the mounting nuts.
(b) Using a brass bar and hammer, tap on the bolt heads and remove the cone washers.
CAUTION: Do not tap the hub body when removing the cone washer. If the stud bolt is damaged or deformed, replace with a new one.
(c) Pull off the hub body.
4. REMOVE BRAKE SUBASSEMBLY
(a) Using a screwdriver, pry out the snap ring.
CAUTION: Never strike brake shoe with the screwdriver, always apply the screwdriver to the brake drum to remove the snap ring.
(b) Using a screwdriver, pry off the brake subassembly.
CAUTION: Do not drop the brake shoe subassembly.