4 Runner 4WD V8-4.7L (2UZ-FE) (2003)
7.
Remove the 4 bolts and the engine under cover sub-assembly No. 1.
8.
Remove the 2 nuts and the front stabilizer link assembly LH.
NOTE:
If the front stabilizer link ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
9.
Remove the 2 nuts and the front stabilizer link assembly RH.
10.
Remove the 2 bolts and the front stabilizer bracket No. 1 LH.
11.
Remove the 2 bolts and the front stabilizer bracket No. 1 RH.
12.
Remove the 2 front stabilizer bar bushings No. 1.
13.
Remove the front stabilizer bar.
14.
Separate the tie rod end sub-assembly LH.
A.
Remove the cotter pin and nut.
B.
Using the SST, separate the tie rod end from the steering knuckle arm.
SST P/N: 09628-62011
15.
Separate the tie rod end sub-assembly RH.