4 Runner SR5 2WD V6-3.4L (5VZ-FE) (1997)
3. Install the axle hub to the steering knuckle, by performing these steps.
a. Install the brake dust cover to the steering knuckle with the four bolts, tightening the bolts to 18 Nm (13 ft. lbs.).
b. Using the 09649-17010 SST and a press, install the axle hub to the steering knuckle.
4. Install the ABS speed sensor rotor/spacer.
NOTE: Do not scratch the serration of the speed sensor rotor.
5. Using the 09950-60010 (09951-00650), 09950-70010 (09951-07150) SST and a press, install the bearing spacer.
6. If it is a two wheel drive vehicle, install the grease cap.
7. If it is a four wheel drive vehicle, install a new (inside) oil seal by doing the following.
a. Using the 09527-17011 SST and a plastic hammer, install a new (inside) oil seal .
NOTE: Strike the SST on its circumference evenly.
b. Coat MP grease to the oil seal lip.
Front Wheel Hub Bolt
HUB BOLT REPLACEMENT
1. Remove the front wheel.
2. Remove the brake line bracket from the steering knuckle.
3. Remove the brake caliper and the disc.