Avalon V6-3.0L (1MZ-FE) (1996)
Ignition Cable: Service and Repair
1. DISCONNECT HIGH-TENSION CORDS FROM SPARK PLUGS
-
Using needle-nose pliers, disconnect the cord clamp from the engine wire protector.
-
Disconnect the high - tension cords at the rubber boot.
NOTICE:
-
Do not pull on the cords.
-
Pulling on or bending the cords may damage the conductor inside.
-
Disconnect the high-tension cords from the clamp.
2. DISCONNECT HIGH-TENSION CORDS FROM IGNITION COILS
-
Using a screwdriver, lift up the lock claw and disconnect the holder from the ignition coils.
-
Disconnect the high-tension cord at the grommet.
-
Do not pull on the cord.
NOTICE:
-
Pulling on or bending the cords may damage the conductor inside.
-
Do not wipe any of the oil from the grommet after the high-tension cord is disconnected.
3. REMOVE HIGH-TENSION CORDS SET