Avalon V6-3.0L (1MZ-FE) (1996)
Disconnect the 2 clips, and remove the cover.
3. REMOVE AIR INTAKE CHAMBER ASSEMBLY
Disconnect these cables and connectors:
^ Accelerator cable
^ A/T throttle cable
^ Throttle position sensor connector
^ IAC valve connector
^ EGR gas temperature sensor connector
^ A/C idle-up valve connector
^ VSV connector for ACIS
^ VSV connector for fuel pressure control
^ California:
^ VSV connector for EVAP
^ VSV connector for EGR
^ DLC1 from bracket on intake air control valve
Remove the 2 nuts, and disconnect the PS pressure tube from the No.1 engine hanger.
Disconnect the hoses, cables, strap and clamp:
(1) Brake booster vacuum hose from intake air control valve for ACIS
(2) PCV hose from PCV valve on RH cylinder head
(3) Ground strap and cable from intake air control valve for ACIS
(4) Ground cable from air intake chamber
(5) Vacuum hose clamp from fuel pipe
(6) 2 water bypass hoses from throttle body
(7) Air assist hose from throttle body
(8) 2 PS air hoses from air intake chamber
(9) California: EVAP hose from pipe on emission control valve set
(10) 2 vacuum hoses from pipes on cylinder head rear plate
(11) Vacuum sensing hose from fuel pressure regulator
(12) Engine wire clamp from emission control valve set