Avalon V6-3.0L (1MZ-FE) (1996)
Ignition Coil: Service and Repair
IGNITION COILS REMOVAL
1. DISCONNECT HIGH-TENSION CORDS FROM IGNITION COILS
-
Using a screwdriver, lift up the lock claw and disconnect the holder from the ignition coils.
-
Disconnect the high-tension cord at the grommet.
-
Do not pull on the cord.
NOTICE:
-
Pulling on or bending the cords may damage the conductor inside.
-
Do not wipe any of the oil from the grommet after the high-tension cord is disconnected.
2. REMOVE IGNITION COILS
-
Disconnect the 3 connectors.
-
Remove the 3 bolts and 3 ignition coils from the LH cylinder head.
IGNITION COILS INSTALLATION
1. INSTALL IGNITION COILS
-
Install the 3 ignition coils with the 3 bolts.
Torque: 8 Nm (80 kgf.cm, 69 in.lb)
-
Connect the 3 connectors.
2. CONNECT HIGH-TENSION CORDS TO IGNITION COILS
-
Assemble the holder and grommet.
-
Align the spline of the ignition coil with the spline of the holder, and push in the cord.