Avalon V6-3.0L (1MZ-FE) (1996)
Spark Plug: Service and Repair
1. REMOVE IGNITION COILS AND IGNITION CABLES FROM THE SPARK PLUGS.
-
Using needle-nose pliers, disconnect the cord clamp from the engine wire protector.
-
Disconnect the high - tension cords at the rubber boot.
NOTICE:
-
Do not pull on the cords.
-
Pulling on or bending the cords may damage the conductor inside.
-
Disconnect the 3 ignition coil connectors.
-
Remove the 3 bolts and 3 ignition coils from the LH cylinder head.
2. REMOVE SPARK PLUGS
-
Using a 16 mm plug wrench, remove the 6 spark plugs from the RH and LH cylinder heads.
3. REINSTALL SPARK PLUGS
-
Using a 16 mm plug wrench, install the 6 spark plugs to the RH and LH cylinder heads.
Torque: 18 Nm (180 kgf.cm, 13 ft.lb)