Avalon V6-3.0L (1MZ-FE) (1996)
2. Install PS vane pump assembly with presser feed tube. Temporarily tighten the 2 (A and B) bolts.
3. Install drive belt.
a. Adjust drive belt tension.
b. Using Special Service Tool (SST) 09249 - 63010, torque the A bolt to 29 Nm (21 ft. lbs.).
NOTE:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch)..
-
Disconnect the clamp with engine wire.
c. Torque the B bolt to 43 Nm (32 ft. lbs.).
d. Connect the connector to the oil pressure switch.
4. Connect pressure feed tube.
a. Using SST 09631 - 22020, connect the tube, then tighten to 20 Nm (15 ft. lbs.).
NOTE:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
-
This torque value is effective in case that SST is parallel to a torque wrench.
b. Install the 2 clamp plates and 2 holders to the tube.
c. Tighten the bolt.