Avalon V6-3.5L (2GR-FE) (2006)
-
Do not start the engine for at least 2 hours after installation.
b. Install the camshaft housing RH, and tighten the 12 bolts in the order shown in the illustration.
Torque: 25 Nm (255 kgf-cm, 18 ft. lbs.)
NOTICE: Make sure that the knock pin of the camshaft is positioned as shown in the illustration before installing the camshaft housing RH.
c. Using several steps, tighten the 8 bearing cap bolts uniformly in the sequence as shown in the illustration.
Torque: 16 Nm (163 kgf-cm, 12 ft. lbs.)
NOTICE: Remove all excess seal packing after installing the bearing cap bolts.
d. Install the 3 new gaskets to the camshaft bearing cap.
44. INSTALL CHAIN TENSIONER ASSEMBLY NO.2
a. Install the chain tensioner No.2 with the bolt.
Torque: 21 Nm (214 kgf-cm, 15 ft. lbs.)