Avalon V6-3.5L (2GR-FE) (2006)
Engine/Hybrid System - Emission Control - "Air Fuel Ratio Sensor Manual:
^
2006 Avalon:
Engine/Hybrid System - Emission Control - "2GR-FE Emission Control: Air Fuel Ratio Sensor: Removal and Installation"
^
2007 Avalon:
Engine/Hybrid System - Emission Control - "2GR-FE Emission Control: Air Fuel Ratio Sensor: Removal and Installation"
^
2007 Camry:
Engine/Hybrid System - Emission Control - "2GR-FE Emission Control: Air Fuel Ratio Sensor: Removal and Installation"
^
2008 Camry:
Engine/Hybrid System - Emission Control - "2GR-FE Emission Control: Air Fuel Ratio Sensor: Removal and Installation"
B.
Bank 1 (RH) Exhaust Manifold Sub-assembly:
(1)
Disconnect the air fuel ratio sensor connector clamp.
(2)
Uniformly loosen and remove the 6 nuts.
(3)
Remove the manifold and gasket.
(4)
Install a NEW gasket as shown.
(5)
Install the NEW exhaust manifold sub-assembly RH with the 6 nuts and reassemble in reverse order.
Torque: 21 N.m (214 kg.cm, 15 ft.lbf)
NOTE
The revised A/F sensor is not compatible with the previous A/F sensors or previous Bank / (RH) exhaust manifold.
3.
After the repair is complete clear any stored DTCs and test drive to confirm the repair.