toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Brake Rotor/Disc|Adjustments > < Brake Rotor/Disc|Front
Page 1
background image

Brake Rotor/Disc: Testing and Inspection
Rear

Measuring Disc Thickness

DISC THICKNESS

Using a micrometer, measure the Disc thickness.
Standard thickness: 9.0 mm (0.354 inch)
Minimum thickness: 8.0 mm (0.315 inch)
Replace the Disc if the Disc's thickness is at the minimum thickness or less. Replace the Disc or grind it on a lathe if it is badly scored or worn
unevenly.

Measuring Disc Runout

DISC RUNOUT

Using a dial indicator, measure Disc runout 10 mm (0.39 inch) from the outer edge of the Disc.
Maximum Disc runout: 0.15 mm (0.0059 inch)
If the Disc's runout is maximum value or greater, check the bearing play in the axial direction and check the Axle Hub runout. If the bearing play
and Axle Hub runout are not abnormal, adjust the Disc runout.

DRUM-IN-HAT

Using a vernier Calipers, measure the inside diameter of the Disc.
Standard inside diameter: 170 mm (6.69 inch) 
Maximum inside diameter: 171 mm (6.73 inch)
Replace the Disc if the inside diameter is at the maximum value or more. Replace the Disc or grind it with a lathe if the Disc is scored or is worn
unevenly.

Brake Rotor/Disc|Adjustments > < Brake Rotor/Disc|Front