Avalon XL V6-3.0L (1MZ-FE) (1997)
b. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 inch).
NOTE: If the deviation exceeds the maximum, replace the axle hub with the bearing.
4. Remove rear axle hub.
a. Remove the 4 bolts and rear axle hub.
[Torque: 80 Nm (59 ft. lbs.)]
b. Remove the O-ring.
Installation Note: Coat a new O-ring with MP grease.
c. Support the backing plate securely.
5. Install in reverse order of removal, noting the torque specifications in brackets [ ].
6. After installation, check the ABS speed sensor signal (ABS equipped) and rear wheel alignment.