Avalon XLS V6-3.0L (1MZ-FE) (1998)
Hydraulic Control Assembly - Antilock Brakes: Testing and Inspection
ON-VEHICLE INSPECTION
HINT: Using the ABS actuator checker Special Service Tool (SST) 09990-00150, 09990-00250, 09990-00360, 09990-00450 or equivalent, check
the operation of the actuator. If the actuator does not operate, check the operation of sub-wire harness G refer to "Testing and Inspection". If the
solenoid and/or pump motor relay are abnormal, replace the relay and inspect the actuator operation again.
1. Inspect battery positive voltage.
Battery positive voltage: 10 - 14 Volts
2. Disconnect connectors.
Disconnect the 2 connectors from the actuator.
3. Connect actuator checker SST 09990-00150, 09990-00250, 09990-00360, 09990-00450.
a. Connect the actuator checker (SST) to the actuator side wire harness via the sub-wire harness (SST), as shown.
b. Connect the red cable of the checker to the battery positive (+) terminal and black cable to the negative (-) terminal. Connect the black cable of
the sub-wire harness to the battery negative (-) terminal or body ground.
c. Place the "SHEET A" SST 09990-00163, on the actuator checker.
4. Inspect brake actuator operation.
a. Start the engine, and run it at idle.
b. Turn the selector switch of the actuator checker to "FRONT RH" position.