Avalon XLS V6-3.0L (1MZ-FE) (1998)
(f) Place the 4 spacers in position on the intake manifold.
(g) Apply a light coat of spindle oil or gasoline on the place where a intake manifold touches an O-ring of the injector.
(h) Place the delivery pipes and fuel pipe together with the 6 injectors in position on the intake manifold.
(i) Temporarily install the 4 bolts holding the delivery pipes to the intake manifold.
(j) Temporarily install the bolt holding the fuel pipe to the intake manifold.
(k) Check that the injectors rotate smoothly.
HINT: If injectors do not rotate smoothly the probable cause is incorrect installation of O-rings. Replace the O-rings.
(l) Position the injector connector outward.
(m)Tighten the 4 bolts holding the delivery pipes to the intake manifold.
Torque: 10 N.m (100 kgf-cm, 7 ft.lbf)
(n) Tighten the bolt holding the fuel pipe to the intake manifold.
Torque: 19.5 N.m (200 kgf-cm, 14 ft.lbf)
2. CONNECT FUEL INLET PIPE