Avalon XLS V6-3.0L (1MZ-FE) (1998)
^
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
^
After installation, shake the sensor assembly to check that there is no looseness.
2. INSTALL FRONT SEAT OUTER BELT RETRACTOR
a. Install the retractor with 2 bolts.
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
Upper bolt: 7.4 N.m (75 kgf.cm, 65 in..lbf)
Lower bolt: 41 N.m (420 kgf.cm, 30 ft.lbf)
b. Connect the retractor switch connector.
c. Connect the pretensioner connector.
3. INSTALL THESE PARTS
a. Center pillar lower garnish
b. Front door scuff plate
c. Rear door scuff plate