Avalon XLS V6-3.0L (1MZ-FE) (1998)
Inspect the entire length of webbing for damage and replace the assembly if needed. Be careful NOT to damage the webbing during repair.
3.
Install the NEW tongue plate stopper
A.
Install a NEW tongue plate stopper in the hole of the webbing.
NOTE
Be sure to install the stopper in the correct direction as shown in the illustration.
B.
Pinch the tongue plate stopper into the webbing using the tool shown in Figure 3 or use a small "C" clamp.
NOTE
To prevent damage to the plastic tongue plate stopper when using a "C" clamp device, use light to moderate clamping force when
crimping the two halves of the tongue plate stopper together.
HINT
Press the adjustment screw locating the male and female parts of the tongue plate stopper parallel to each other.