toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Bleeding|Page 7078 > < Bleeding|Page 7076
Page 6
background image

NOTICE:
-

If brake fluid leaks onto any painted surface of the vehicle, wash or remove it completely.

-

Bleed air by following the steps displayed on the intelligent tester.

-

Do not bend or damage the brake line.

-

Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting points.

-

Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

-

This torque value is effective when SST is parallel to a torque wrench.

HINT:  Air can be easily bled from the front brake system if air has been bled from the master cylinder when replacing the brake master
cylinder assembly.

(g) Use the SST to fully tighten the brake stroke simulator line.

SST: 09023-00101
Without SST - Torque: 15 Nm (155 kgf-cm, 11ft-lbf)
With SST - Torque: 14 Nm (143 kgf-cm, 10ft-lbf)

NOTICE:
-

If brake fluid leaks onto any painted surface of the vehicle, wash or remove it completely.

-

Bleed air by following the steps displayed on the intelligent tester.

-

Do not bend or damage the brake line.

-

Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting points.

-

Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

-

This torque value is effective when SST is parallel to a torque wrench.

HINT:  Air can be easily bled from the front brake system if air has been bled from the master cylinder when replacing the brake master
cylinder assembly.

5. BLEED FRONT BRAKE SYSTEM

HINT:  Air can be easily bled from the front brake system if air has been bled from the master cylinder when replacing the brake master
cylinder assembly.

NOTICE:
-

If brake fluid leaks onto any painted surface of the vehicle, wash or remove it completely.

-

Bleed air by following the steps displayed on the intelligent tester.

(a) Depress the brake pedal several times and bleed the front brake system from the bleeder plugs on the front brake cylinders RH and LH.

HINT:  Repeat the procedure until air is completely bled from the front brake system.

Bleeding|Page 7078 > < Bleeding|Page 7076