Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
Drive Motor Control Module: Service and Repair
Removal and Installation
REMOVAL
1. REMOVE LUGGAGE TRIM SERVICE HOLE COVER
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH
4. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH
5. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
6. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
7. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
8. REMOVE WINDSHIELD WIPER MOTOR AND LINK
9. SEPARATE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSY
10. REMOVE COWL TOP OUTER PANEL SUB-ASSEMBLY
11. REMOVE HYBRID VEHICLE CONTROL ECU
a. Remove the 3 nuts.
b. Disconnect the 2 connectors and remove the hybrid vehicle control ECU.
1. Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 connectors.
NOTE: After disconnecting the connectors, make sure that dirt, water and other foreign matter do not contact the connecting parts of the
connectors.
2. Remove the hybrid vehicle control ECU.
c. Remove the 3 screws and ECU cover.