Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
(b) Measure the resistance between terminals 6 (CANH) and 16 (BAT), and between terminals 14 (CANL) and 16 (BAT) of the DLC3 each
time a connector is disconnected.
Standard resistance:
OK -- CHECK FOR SHORT TO B+ IN CAN BUS WIRE
NG -- Continue to next step.
3. CHECK FOR SHORT TO B+ IN CAN BUS WIRE
(a) Disconnect connectors from the No. 1 CAN J/C one at a time.
HINT: Disconnect the ECU and sensor connectors other than the DLC3 branch wires and CAN main bus wires between the No. 1 CAN J/C
and No. 3 CAN J/C.
(b) Measure the resistance between terminals 6 (CANH) and 16 (BAT), and between terminals 14 (CANL) and 16 (BAT) of the DLC3 each
time a connector is disconnected.