Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
Standard resistance:
(c) Reinstall the IGCT relay.
NG -- REPLACE IGCT RELAY
OK -- Continue to next step.
6. CHECK HARNESS AND CONNECTOR (HV CONTROL ECU - IGCT RELAY)
(a) Disconnect the A61 hybrid vehicle control ECU connector.
(b) Remove the engine IGCT relay from the engine room R/B.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance (Check for open):
Standard resistance (Check for short):
(d) Reinstall the engine room J/B.
(e) Reconnect the hybrid vehicle control ECU connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
7. INSPECT ECM (IGSW VOLTAGE)