toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Engine/Hybrid Controls - MIL ON/DTC P0A84 Set|Page 352 > < Engine/Hybrid Controls - MIL ON/DTC P0A84 Set|Page 346
Page 1
background image

Engine Control Module: Customer Interest
Engine/Hybrid Controls - MIL ON/DTC P0A84 Set

T-SB-0102-09

Rev1

April 6, 2009

MIL "ON" DTC P0A84

Service Category
Engine/Hybrid System

Section
Hybrid/Battery Control System

Market
USA

Applicability

TSB REVISION NOTICE

^

September 23, 2009 Rev1:

^

The Introduction has been updated and a note has been added to the Production Change Information section to clarify only Tsutsumi-built
vehicles are applicable to this TSB.

Any previous printed versions of this service bulletin should be discarded.

The information contained in this TSB supersedes TSB No. EGO60-06.

TSB SUPERSESSION NOTICE

^ This bulletin has been updated for the use of TIS Techstream.

^ The procedures in this bulletin will update the software for both the HV ECU and ECM/PCM.

^ Calibration information has been updated.

TSB No. EGO60-06 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before
proceeding.

Introduction

Some 2007 model year Tsutsumi-built Camry HV vehicles may exhibit a MIL "ON" condition with DTC P0A84 (Hybrid Battery Pack Cooling Fan 1).
Improvements have been made to the HV ECU software to correct this condition. Use the following repair procedure to address customer concerns.

Production Change Information

This TSB applies to vehicles produced BEFORE the Production Change Effective VIN shown.

This TSB is ONLY applicable to vehicles with VINs beginning with JTN. Vehicles with a VIN beginning with 4T1 do NOT apply.

Engine/Hybrid Controls - MIL ON/DTC P0A84 Set|Page 352 > < Engine/Hybrid Controls - MIL ON/DTC P0A84 Set|Page 346