Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
3. REMOVE ENGINE UNDER COVER RH
4. REMOVE ENGINE UNDER COVER LH
5. REMOVE FRONT AIRBAG SENSOR
(a) Remove the bolt and front airbag sensor from the body.
(b) Disconnect the connector from the front airbag sensor.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
From 10-2006
SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: REMOVAL
REMOVAL
HINT:
-
Use the same procedure for the RH side and the LH side.
-
The procedure listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing See: Service Precautions/Vehicle Damage Warnings.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
3. REMOVE ENGINE UNDER COVER RH
4. REMOVE ENGINE UNDER COVER LH
5. REMOVE FRONT AIRBAG SENSOR