Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
_hybrid/Page-2628004.png)
-
When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between
other parts.
(e) Check that there is no looseness in the installation parts of the front airbag sensor.
2. INSTALL ENGINE UNDER COVER LH
3. INSTALL ENGINE UNDER COVER RH
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTICE: Some systems need initialization after reconnecting the cable to the negative battery terminal.
6. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Airbag System/Diagnosis System.
From 10-2006
SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: INSTALLATION
INSTALLATION
1. INSTALL FRONT AIRBAG SENSOR
(a) Check that the power switch is turned off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
(c) Connect the connector.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
(d) Install the front airbag sensor with the bolt.
Torque: 17.5 Nm (179 kgf-cm, 13ft-lbf)
NOTICE:
-
If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with
a new one.
-
When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between
other parts.
(e) Check that there is no looseness in the installation parts of the front airbag sensor.
2. INSTALL ENGINE UNDER COVER LH
3. INSTALL ENGINE UNDER COVER RH
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.