toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Procedures|Page 10923 > < Procedures|Page 10921
Page 40
background image

(a) Check the degree of the tilt when the ELR begins to lock.

(1) Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the

belt.

NOTICE:  Do not disassemble the retractor.

(b) Align the claw with the seat belt positioning hole and install the rear seat outer belt assembly with the bolt.

Torque: 42 Nm (428 kgf-cm, 31ft-lbf)

2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY See: Rear Seat Inner Belt Assembly/Installation
3. INSTALL REAR SEAT SHOULDER BELT HOLE COVER See: Rear Seat Inner Belt Assembly/Installation
4. INSTALL REAR SEAT SHOULDER BELT COVER See: Rear Seat Inner Belt Assembly/Installation
5. CONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side)

(a) Connect the floor end of the rear seat outer belt assembly with the bolt.

Torque: 42 Nm (428 kgf-cm, 31ft-lbf)

NOTICE:  Do not allow the anchor part of the rear seat outer belt assembly to overlap the protruding part of the floor panel.

(b) Check if the ELR locks.

NOTICE:  The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.

6. CONNECT REAR SEAT OUTER BELT ASSEMBLY (for RH Side)

(a) Connect the floor end of the rear seat outer belt assembly with the bolt.

Torque: 42 Nm (428 kgf-cm, 31ft-lbf)

NOTICE:  Do not allow the anchor part of the rear seat outer belt assembly to overlap the protruding part of the floor panel.

(b) Check if the ELR locks.

NOTICE:  The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.

7. INSTALL ROOF SIDE INNER GARNISH LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof

Headlining/Installation

8. INSTALL ROOF SIDE INNER GARNISH RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof

Headlining/Installation

9. CONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH See: Rear Seat Inner Belt Assembly/Installation

10. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH See: Child Restraint/Service and Repair/Installation
11. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and

Procedures|Page 10923 > < Procedures|Page 10921