Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
Knock Sensor: Service and Repair
Removal
From 03-2006 to 10-2006
2AZ-FXE ENGINE CONTROL SYSTEM: KNOCK SENSOR: REMOVAL
REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Removal
4. DRAIN COOLANT (for Engine) See: Engine, Cooling and Exhaust/Cooling System/Coolant/Testing and Inspection/Coolant (for Engine)
5. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH See: Wiper and Washer Systems/Wiper Motor/Service and
Repair/Removal
6. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH See: Wiper and Washer Systems/Wiper Motor/Service and
Repair/Removal
7. REMOVE FRONT FENDER TO COWL SIDE SEAL LH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Removal
8. REMOVE FRONT FENDER TO COWL SIDE SEAL RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Removal
9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY See: Wiper and Washer Systems/Wiper Motor/Service and
Repair/Removal
10. SEPARATE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
11. REMOVE WINDSHIELD WIPER MOTOR AND LINK See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Removal
12. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY
(a) Remove the 4 bolts, 4 nuts and cowl top panel outer sub-assembly.
13. REMOVE AIR CLEANER CAP SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal
14. REMOVE AIR CLEANER CASE SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Removal
15. REMOVE THROTTLE BODY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and Repair/Removal
16. DISCONNECT FUEL TUBE See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and Repair/Removal
17. REMOVE FUEL DELIVERY PIPE WITH INJECTOR See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and
Repair/Removal
18. REMOVE INTAKE MANIFOLD
(a) Disconnect the union to check valve hose from the brake booster.
(b) Disconnect the camshaft timing oil control valve connector.
(c) Remove the wire harness clamp.
(d) Remove the union to check valve hose from the vacuum hose clamp.
(e) Remove the 5 bolts, 2 nuts and intake manifold.