Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
8. INSTALL AIR CLEANER INLET ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Installation
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Installation
10. ADD COOLANT (for Engine) See: Engine, Cooling and Exhaust/Cooling System/Coolant/Testing and Inspection/Coolant (for Engine)
11. INSPECT FOR COOLANT LEAK (for Engine) See: Engine, Cooling and Exhaust/Cooling System/Testing and Inspection/Cooling System
12. INSPECT FOR FUEL LEAK See: Powertrain Management/Fuel Delivery and Air Induction/Testing and Inspection
13. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Installation
14. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY
(a) Install the cowl top panel outer sub-assembly with the 4 bolts and 4 nuts.
Bolt - Torque: 5.0 Nm (51 kgf-cm, 44in-lbf)
Nut - Torque: 85 Nm (867 kgf-cm, 63ft-lbf)
15. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Actuators and Solenoids -
Engine/Variable Valve Timing Actuator/Service and Repair/Installation
16. INSTALL WINDSHIELD WIPER MOTOR AND LINK See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Installation
17. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY See: Wiper and Washer Systems/Wiper Motor/Service and
Repair/Installation
18. INSTALL FRONT FENDER TO COWL SIDE SEAL LH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Installation
19. INSTALL FRONT FENDER TO COWL SIDE SEAL RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Installation
20. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH See: Wiper and Washer Systems/Wiper Motor/Service and
Repair/Installation
21. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH See: Wiper and Washer Systems/Wiper Motor/Service and
Repair/Installation
22. PERFORM INITIALIZATION
(a) Perform initialization procedure See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTICE: Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.
From 10-2006
2AZ-FXE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION
INSTALLATION
1. INSTALL KNOCK SENSOR
(a) Install the knock sensor with the nut.
Torque: 20 Nm (204 kgf-cm, 15ft-lbf)
NOTICE: Make sure that the knock sensor is in the correct position.
(b) Connect the knock sensor connector.
2. INSTALL INTAKE MANIFOLD