Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
(5) Using SST, measure the clearance of the outboard joint boot clamp.
SST: 09240-00020
Clearance:
0.5 to 1.5 mm (0.0197 to 0.0591 in.)
NOTICE: If the measured value is greater than the specified value, retighten the clamp.
(b) for One touch type:
(1) Using a screwdriver, install the outboard joint boot clamp as shown in the illustration.
7. INSTALL NO. 2 FRONT AXLE OUTBOARD JOINT BOOT CLAMP
(a) for Omega type:
(1) Install the No. 2 outboard joint boot clamp onto the boot.
(2) Place SST onto the No. 2 outboard joint boot clamp.
SST: 09521-24010
(3) Tighten the SST so that the No. 2 outboard joint boot clamp is pinched.
NOTICE: Do not overtighten the SST.
(4) Using SST, measure the clearance of the No. 2 outboard joint boot clamp.