Camry V6-3.0L (1MZ-FE) (2004)
HINT
Tape the screwdriver tip before use.
4.
Remove the two screws that are behind the seat switches.
5.
Remove the two screws at the front of the seat that holds the seat trim garnish in place.
HINT
Tip the seat back for easier access.
6.
Tip the seat forward and remove the straps securing the seat cover to the bottom of the seat.
HINT
Remove the headrest and shift the entire seat towards the rear of the vehicle 6 inches (15.24 cm) to gain clearance to tip the seat.
7.
Remove the two screws securing the seat trim garnish to the back of the seat.
8.
Disconnect the electrical connector for the lumbar switch and remove the seat trim garnish.