Camry V6-3.3L (3MZ-FE) (2005)
Drive Belt: Service and Repair
V (Cooler Compressor to Crankshaft Pulley) Belt No.1
V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
REPLACEMENT
1. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
a. Loosen the bolt C.
b. Loosen the bolt A.
c. Loosen the bolt B and remove the cooler V belt No.1.
2. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
a. Temporarily install the cooler V belt No.1 as illustrated.
3. ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
a. Apply drive belt tension by turning the bolt B.
Drive belt tension:
New Belt: 165 ± 27 lbf
Used belt: 88 ± 22 lbf
HINT:
-
"New belt" refers to a belt which has been used less than 5 minutes on a running engine.
-
Used belt refers to a belt which has been used on a running engine for 5 minutes or more.