Camry V6-3.3L (3MZ-FE) (2005)
Engine Control Module: Service and Repair
Removal and Installation
REPLACEMENT
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE RH
3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
4. REMOVE INSTRUMENT PANEL UNDER COVER SUB ASSEMBLY NO.1
5. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY LOWER
6. REMOVE ECM
a. Remove the 2 wire harness clamps.
b. Disconnect the 5 ECM connectors.
c. Remove the 2 nuts and ECM.
7. REMOVE ECM BRACKET
a. Remove the 2 screws and ECM bracket.
8. REMOVE ECM BRACKET NO.2
a. Remove the 2 screws and ECM bracket.
9. INSTALL ECM BRACKET NO.2