Camry V6-3.3L (3MZ-FE) (2005)
b. Using SST, remove the tie rod assembly LH from the steering knuckle.
SST 0962-62011
8. DISCONNECT TIE ROD ASSEMBLY RH
SST 0962-62011
HINT: Remove the RH side by the same procedures with LH side.
9. DISCONNECT STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
a. Loosen the bolt and remove the clamp from the steering column hole cover No. 1.
b. Disconnect the steering column hole cover No.2 from the steering column hole cover No. 1.
c. Loosen the bolt.
d. Place matchmarks on the steering intermediate shaft sub-assembly and rack & pinion power steering gear assembly.
e. Remove the bolt and separate the steering intermediate shaft sub-assembly.
10. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH
a. Remove the nut and disconnect the front stabilizer link assembly from the absorber.
HINT: If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.
11. DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH