Camry V6-3.5L (2GR-FE) (2008)
Required Tools & Equipment
NOTE
Additional SSTs may be ordered by calling 1-800-933-8335.
NOTE
Additional TIS Techstream units may be ordered by calling Approved Dealer Equipment (ADE).
Repair Procedure
CAUTION
Work must be started more than 90 seconds AFTER the ignition switch is turned to the LOCK position and the negative (-) terminal cable is
disconnected from the battery. The SRS is equipped with a back-up power source. If work is started within 90 seconds from disconnecting the
negative (-) terminal cable of the battery, the SRS may deploy.
1. Disconnect cable from the negative (-) battery terminal.
2. For vehicles equipped with a driver side knee airbag follow the Repair Manual instructions for the correct removal procedure.
NOTE
For vehicles without a driver side knee airbag, proceed to step 3.
^
2007 / 2008 / 2009 Camry:
Vehicle Interior - Supplemental Restraint System - "Driver Side knee Airbag Assembly: Removal"
^
2007 (to 10/2006 / 2007 (TMMK) / 2007 (TMC) / 2008 (TMMK) / 2008 (TMC) / 2009 (TMMK) / 2009 (TMC) Camry HV:
Vehicle Interior - Supplemental Restraint System - "Driver Side knee Airbag Assembly: Removal"
NOTE
After removing the driver side knee airbag, proceed to step 9.
3. Remove the LH front door scuff plate by disengage the 7 claws and 4 clips.