Camry V6-3.5L (2GR-FE) (2008)
REPLACEMENT
1. REMOVE REAR WHEEL
2. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY (See: Suspension/Rear Knuckle/Service and Repair/Removal)
3. REMOVE REAR DISC (See: Brakes and Traction Control/Parking Brake System/Service and Repair/Disassembly)
4. REMOVE REAR AXLE HUB BOLT
(a) Temporarily install the 2 nuts and washers to the rear axle hub bolt as shown in the illustration.
(b) Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.
SST: 09628-10011
5. INSTALL REAR AXLE HUB BOLT
(a) Install a washer and nut to a new bolt as shown in the illustration.
(b) Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.
6. INSTALL REAR DISC (See: Brakes and Traction Control/Disc Brake System/Service and Repair/Rear Brake/Reassembly)
7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (See: Suspension/Rear Knuckle/Service and Repair/Installation)
8. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)