Camry CE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
_mfi/Page-1511001.png)
Hydraulic Control Assembly - Antilock Brakes: Testing and Inspection
ABS (TMC/Denso Made)
ON-VEHICLE INSPECTION
HINT: Using the ABS actuator checker (Special Service Tools) (SST), check the operation of the actuator. If the actuator does not operate, check the
operation of sub-wire harness G. If the solenoid and/or pump motor relay are abnormal, replace the relay and inspect the actuator operation again.
1. INSPECT BATTERY POSITIVE VOLTAGE
Battery positive voltage: 10-14 VOLTS
2. DISCONNECT CONNECTORS
Disconnect the 2 connectors from the actuator.
3. CONNECT ACTUATOR CHECKER (SST)
a. Connect the actuator checker (SST) to the actuator side wire harness via the sub-wire harness (SST), as shown.
SST 09990-00150, 09990-00250, 09990-00300, 09990-00360
b. Connect the red cable of the checker to the battery positive (+) terminal and black cable to the negative (-) terminal. Connect the black cable of
the sub-wire harness to the battery negative (-) terminal or body ground.
c. Place the "SHEET P" (SST) on the actuator checker.
SST 09990-00430
4. INSPECT BRAKE ACTUATOR OPERATION
a. Start the engine, and run it at idle.
b. Turn the selector switch of the actuator checker to "FRONT LH" position.
