Toyota Workshop Service and Repair Manuals

Crankshaft: Specifications

SERVICE SPECIFICATIONS 

Thrust Clearance:

Standard ..........................................................................................................................................................  0.04 - 0.24 mm (0.0016 - 0.0095 inch)
Maximum .................................................................................................................................................................................  0.30 mm (0.0118 inch)

Main Journal Oil Clearance:

Standard:

No.1 and No.4 .......................................................................................................................................  0.014 - 0.036 mm (0.0006 - 0.0014 inch)
No.2 and No.3 .......................................................................................................................................  0.026 - 0.048 mm (0.0010 - 0.0019 inch)

Maximum:

No.1 and No.4 ....................................................................................................................................................................  0.05 mm (0.0020 inch)
No.2 and No.3 ....................................................................................................................................................................  0.06 mm (0.0024 inch)

Main Journal Diameter ..................................................................................................................................  60.988 - 61.000 mm (2.4011 - 2.4016 inch)
Crank Pin Diameter .......................................................................................................................................  52.992 - 53.000 mm (2.0863 - 2.0866 inch)
Circle Runout:

Maximum .................................................................................................................................................................................  0.06 mm (0.0024 inch)

Main Journal Taper and Out-Of-Round:

Maximum .................................................................................................................................................................................  0.02 mm (0.0008 inch)

Crank Pin Taper and Out-Of-Round:

Maximum .................................................................................................................................................................................  0.02 mm (0.0008 inch)

TORQUE SPECIFICATIONS 

Crankshaft To:

Crankshaft Pulley ........................................................................................................................................................................  215 Nm (159 ft. lbs.)
Drive Plate ......................................................................................................................................................................................  83 Nm (61 ft. lbs.)
Flywheel .........................................................................................................................................................................................  83 Nm (61 ft. lbs.)