Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Spark Plug: Testing and Inspection
Spark Plugs
NOTICE:
-
Never use a wire brush for cleaning.
-
Never attempt to adjust the electrode gap on a used spark plug.
-
Spark plugs should be replaced every 100,000 km (60,000 miles).
1. Disconnect high-tension cords from spark plugs.
2. Inspect electrode.
Using a megger (insulation resistance meter), measure the insulation resistance.
Standard correct insulation resistance: 10 M ohms or more
If the resistance is less than specified, proceed to step 4.
HINT: If a megger is not available, the following simple method of inspection provides fairly accurate results.
Simple Method:
(a) Quickly race the engine to 4,000 rpm 5 times.
(b) Remove the spark plug. (See step 3)
(c) Visually check the spark plug.
If the electrode is dry ... OK
If the electrode is wet... Proceed to step 4
(d) Reinstall the spark plug. (See step 7)
3. Remove spark plugs.
Using a 16 mm plug wrench, remove the 4 spark plugs.