Camry CE Sedan 4-Door Fuel Filter Maintenance and Pressure Release
Fuel Pressure Release: Service and Repair
FUEL PRESSURE RELEASE PROCEDURE
1. When disconnecting the high fuel pressure line, a large amount of gasoline will spill out, so observe these procedures:
(a) Disconnect the fuel pump connector.
(b) Start the engine. After the engine has stopped on its own, turn the ignition switch OFF.
(c) Put a container under the fuel filter.
(d) Slowly loosen the connection.
(e) Disconnect the connection.
(f) Plug the connection with a rubber plug.
(g) Reconnect the fuel pump connector.
2. When connecting the flare nut or union bolt on the high pressure pipe union, observe these procedures:
Union Bolt Type:
(a) Always use 2 new gaskets.
(b) Tighten the union bolt by hand.
(c) Tighten the union bolt to the specified torque.
Torque: 29 N.m (300 kgf.cm, 21 ft.lbf)
Flare Nut Type:
(a) Apply a light coat of engine oil to the flare nut, and tighten the flare nut by hand.