Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Alignment: Service and Repair
Front
1. Measure vehicle height.
Tire size: 195/70R14
Height: Front 212 mm (8.35 inch) / Rear 264 mm (10.39 inch)
Tire size: 205/65R15
Height: Front 215 mm (8.46 inch) / Rear 266 mm (10.49 inch)
a. Front measuring point; measure from the ground to the center of the front side lower suspension arm mounting bolt.
b. Rear measuring point; measure from the ground to the center of the front side strut rod mounting bolt.
NOTE:
-
Before inspecting the wheel alignment, adjust the vehicle height to the specification.
-
If the vehicle height is not to the specification, try to adjust it by pushing down on or lifting the body.
2. Install camber-caster-kingpin gauge onto vehicle or position vehicle on wheel alignment tester Follow the specific instructions of the equipment
manufacturer.
3. Inspect camber, caster and steering axis.
Camber: -0° 36' ± 45' (-0.6° ± 0.75°).
Left-right error: 45' (0.75°) or less
Caster: +2° 10' ± 45' (+2.17° ± 0.75°).
Left-right error: 45' (0.75°) or less
Steering Axis Inclination +13° 01' ± 45' (+13.02° ± 0.75°).
Left-right error: 45' (0.75°) or less
CAUTION: If the caster and steering axis inclination are not within the specification, after the camber has correctly adjusted, recheck the
suspension parts for damaged and/or worn out parts.