Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Valve Body: Service and Repair
Removal and Installation
ON-VEHICLE REPAIR
1. Drain transaxle fluid.
Torque: 49 N.m (500 kgf/cm, 36 ft. lbs.).
2. Remove oil pan and gasket.
REMOVAL NOTICE: Some fluid will remain in the oil pan. Remove the oil pan bolts, and carefully remove the oil pan assembly. Discard the
gasket.
Torque: 4.9 N.m (50 kgf/cm, 43 inch lbs.).
3. Examine particles in pan.
-
Remove the magnets and use them to collect any steel chips. Look carefully at the chips and particles in the pan and on the magnet to
anticipate what type of wear you will find in the transaxle.
Steel (magnetic): bearing, gear and plate wear
Brass (non-magnetic): bushing wear
4. Remove manual valve body detent spring and manual valve body.
a. Remove the detent spring on the manual valve body.
Torque: 10 N.m (100 kgf/cm, 7 ft. lbs.).
INSTALLATION HINT: Check that the manual valve lever is touching the center of the detent spring tip roller.
b. Remove the manual valve body.
Torque: 10 N.m (100 kgf/cm, 7 ft. lbs.).