Camry Coupe 2-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
Throttle Position Sensor: Testing and Inspection
INSPECTION
1. APPLY VACUUM TO THE THROTTLE OPENER.
2. DISCONNECT THE THROTTLE POSITION SENSOR CONNECTOR.
3. INSERT A THICKNESS GAUGE BETWEEN THE THROTTLE STOP SCREW AND STOP LEVER.
4. USING AN OHMMETER MEASURE THE RESISTANCE BETWEEN EACH TERMINAL.
Clearance between
Between
Resistance
lever and stop screw
terminals
0.0 mm (0.0 in)
VTA - E2
0.2 - 5.7 k Ohms
Wide open throttle
VTA - E2
2.0 - 10.2 k Ohms
Always
VC - E2
2.5 - 5.9 k Ohms
0.35 mm (0.014 in)
IDL - E2
2.3 k Ohms or less
0.70 mm (0.028 in)
IDL - E2
Infinity
5. IF NECESSARY, ADJUST THROTTLE POSITION SENSOR AND RETEST.
6. RECONNECT THE SENSOR CONNECTOR.
NOTE: For information on testing the Throttle Position sensor circuit refer to "DTC 41" under the "Trouble Code Charts".
See: Computers and Control Systems/Testing and Inspection