Camry Coupe 2-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
3. INSPECT SHIFT FORKS AND HUB SLEEVES CLEARANCE
Using a feeler gauge, measure the clearance between the hub sleeve and shift fork.
Maximum clearance: 1.0 mm (0.039 in.)
If the clearance exceeds the maximum, replace the shift fork or hub sleeve.
4. INSPECT OUTPUT SHAFT
a. Using a micrometer, measure the outer diameter of the output shaft journal surface.
Minimum outer diameter:
Part A: 31.970 mm (1.2587 in.)
Part B: 37.970 mm (1.4949 in.)
Part C: 31.990 mm (1.2594 in.)
If the outer diameter is less than the minimum, replace the output shaft.
b. Using a dial indicator, check the shaft runout.
Maximum runout: 0.05 mm (0.0020 in.)
If the runout exceeds the maximum, replace the output shaft.
OUTPUT SHAFT ASSEMBLY
HINT: Coat all of the sliding and rotating surface with gear oil before assembly.